Masters Dissertations : Engineering: Recent submissions

  • POWER OPTIMIZATION IN THE THIRD GENERATION MOBILE PHONES 
    ABD ELSADIG, KAMAL OMAR ABDELLA; Supervisor - SHRAF GASIMELSID ABDALLA (Sudan University of Science & Technology, 2006-11-01)
    Due to its improved capabilities for mobile communication, power consumption in 3G phones acts a major role that affects overall system performance. Therefore, the research viewed the problem of power optimization in 3G ...
  • VOICE OVER INTERNET PROTOCOL SECURITY (VOIPsec) 
    MOHAMED, ELFADIL ABDELRAHMAN; Supervisor - SHRAF GASIM ELSEED (Sudan University of Science & Technology, 2006-11-01)
    The thesis examines the voice over internet protocol (VOIP) technology by theoretically studding the basic components, basic architecture, and call establishment of the VOIP system standard protocols (H.323, SIP).VOIP ...
  • Implementation of IPSec Linux Routers 
    Ishag, Khalid Mohammed Saleh; Supervisor - Yahia Adballa Mohammed (Sudan University of Science and Technology, 2010-05-01)
    IPSec is a framework of open standards for ensuring private communications over IP networks which has become the most popular network layer security control. It can provide several types of data protection: confidentiality, ...
  • Digital Filler Design Using Matlab 
    Hamza, Haifa Abdelgadeir Ahmed; Supervisor - Abd Al-Resoul Jabbar Alzubaidi (Sudan University of Science and Technology, 2010-01-01)
    Signals from the sender to the receiver or within the devices are subject to noise due to electromagnetic waves between the signals or because of climate change and other reasons. This noise affects the original signal, ...
  • aduate Studies Performance Characteristics of A turbo Charged Engine with E G R 
    Omer, Eihab Abdelraouf Mustafa; Supervisor - Sabir M Salih; Supervisor , Sabir M Salih (Sudan University of Science and Technology, 2008-01-10)
    ( NO x ) Is a generic term for mono-nitrogen oxides (NO and NO2). These oxides are produced during combustion, especially combustion at high temperatures. At ambient temperatures, the oxygen and nitrogen gases in air ...
  • .Feasibility Study of Using Precast Concrete Products for Residential Buildings in Sudan 
    Almakki, Mudthir Bakri Hassan; Supervisor - Abdalla M. T. Shigidi (Sudan University of Science and Technology, 2007-11-01)
    A methodology was developed to perform economic and financial feasibility for a precast concrete factory which is expected to produce beams, slabs, columns and stairs. The aim was to find a low cost alternative to ...
  • PROGRAMMING THE AT89C51 TO CONTROL THE TEMPERATURE OF POWER STATION 
    ALIMAM, YOUSIF ISHAG MOHAMED; Supervisor - ABDALLAH SALIH ALI (Sudan University of Science and Technology, 2005-09-10)
    This research is to implement microcontrollers to control the superheated steam (main steam) temperature in power plants. There are many types of main steam temperature control, one of them is steam desuperheating ...
  • Using Standard Parts Retrieval To Enhance The Productivity Of AutoCAD 
    A.elgadir, Nasreldin Dafaalla; Supervisor - abdelfaltah Bilal (Sudan University of Science and Technology, 2005-01-10)
    Drawing is the most important issue in design, since it is used in communicating the design to the production staff. Due to the above reasons we prepare a program in side the AutoCAD (customize AutoCAD ...
  • Software Defind Rodios for Third Genration ( SDR for 3G ) 
    Salih, Sami Hassan Omer; Supervisor - Abdel Rasoul Alzubaidi (Sudan University of Science and Technology, 2006-12-01)
    The worldwide standards bodies have developed multiple standards for high- and low-tier cellular and PCS. While each carrier has plans for offering service based on a specific standard, the multiplicity of standards ...
  • Handoffs in Cellular Wireless Networks 
    Mohammed, Khalifa Dai Elnour; Supervisor - Ashraf Gasim Elsid (Sudan University of Science and Technology, 2006-08-01)
    Wireless network is connecting between many nodes without wire line and using network protocols to do this. Network protocols in cellular wireless data network must update routes as a mobile host between cells. These routing ...
  • Minimization of Distribution System Harmonics : Case Study Sudanese Malaysian Steel Factory 
    Mustafa, Mustafa Ahmed Dafalla; Supervisor - Eisa Bashier Mohammed (Sudan University of Science and Technology, 2006-06-01)
    The Harmonics in Distribution Systems come from transformers or saturable reactors, arc furnace, welding machines, florescent lamps, rotating machines and power electronics devices. In general, the non linear loads in which ...
  • Evaluation of Stability of Asphalt-Pavements Study to Verify Marshal Method Case Study : Qassim-Madina Expressway 
    Adam, Taha Mohamed; Supervisor - Omar Abd-Alnabi (Sudan University of Science and Technology, 2006-07-01)
    Hot-mix asphalt, (HMA), is a one of composite material that used for pavement. For this research, HMA is prepared by using Marshal Method for mix design. Marshal method assumes that the bitumen is a binder that binds the ...
  • Enhance Capacity of CDMA Network 
    Hassan, Abdoul Whab; Supervisor - Shraf Gasim Elsid (Sudan University of Science and Technology, 2006-01-01)
    CDMA cellular mobile systems find acceptance particularly in regional centers where there are large geographical areas to cover. The capacity of a CDMA system is limited by the reverse link. The reverse link uses ...
  • A STUDY OF REAL TIME CONTROL APPLICATIONS 
    HAMEDAN, YASIR BABIKER; Supervisor - EISA BASHEIR (Sudan University of Science and Technology, 2007-02-01)
    This Dissertation deals with how to support the Real-Time Applications in Control System. First of all reviewing the characteristics of real-time applications. Observing that, contrary to the popular view that Real-Time ...
  • INSTRUMENT ENGINEERING STANDARD FOR KHARTOUM REFINERY COMPANY 
    Shiekhidriss, Abd elrahman Abd elgadier; Supervisor - Eltahir Mohamed Hussein (Sudan University of Science and Technology, 2007-02-01)
    This standard is applicable for the erection and acceptance of the industrial and civil instrumentation engineering work for khartoum refinery company. The mentioned above standard is being collected through so many ...
  • Digital Protection of Transmission Lines 
    Addalan, Giddani Osman; Supervisor - Khamis Arabeesh saadeldin (Sudan University of Science and Technology, 2006-07-01)
    High voltage transmission lines are designed to transfer large amount of power from one location to another. The length exposed to the environment is a major reason for occurrence of faults on the line. A fault on the lines ...
  • Cathodic Protection Design and Operation 
    Saad, Omer Yahia Mansour; Supervisor - Amir Ahmed Dawood (Sudan University of Science and Technology, 2007-06-01)
    Cathodic protection has probably become the most widely used method for preventing the corrosion deterioration of metallic structures in contact with any forms of electrolytically conducting surface. The most rapid development ...
  • Design of Local Area Network Secured Voice Communication System 
    Ahmed, Musab Abdul Moniem Almakki Mohammed; Supervisor - Saad Daoud Al-Shamma (Sudan University of Science and Technology, 2006-10-01)
    This thesis focuses on designing and implementing a system that can transmit voice over Local Area Network (LAN) in a secure manner. The implementation of the system is done by using both hardware and software. The system ...
  • THE PERFORMANCE OF THE LINEAR KALMAN FILTER 
    Elshiekh, Ahmed Osman; Supervisor - Ali Hassan Fagir (Sudan University of Science and Technology, 2006-02-01)
    The Kalman filter is a mathematical powerful tool that is playing an increasingly important role in a number of applications e.g.: missile tracking, parametric estimation etc. While the Kalman filter has been around for ...
  • Minimizing Waste &Improving Performance Through Total Quality Management (Case study in Elshajara Complex) 
    ELHAJ, MEJDI ABDELRAZIG; Supervisor - ELFATIH ABBAS (sudan university of science and technology, 2005-05-07)
    The aim of this research is to determine and reduce the percentage of the waste in Elshagra Complex at the production line for manufacturing the Bullet Jackets Cal. 7.62*39mm, and to evaluate and analysis of the reasons ...

Search SUST


Browse

My Account