Masters Dissertations : Engineering: Recent submissions

  • Performance Analysis of Channel Coding Techniques in Fourth Generation 
    Almasour, Tagwa AwadElseid; Supervisor,- Ibrahim Khider Altahir (Sudan University of Science and Technology, 2016-03-10)
    nformation sent over channel in presence of channel noise, interference, distortion, and fading; all that can effect in the information and produce errors. This research used Turbo code to reduce this errors in four ...
  • Noise Reducing Using Hybrid Technique In Magnetic Resonances Image 
    Musa, Samah Gaysar; Supervisor,- Zeinab Adam Mustafa (Sudan University of Science and Technology, 2016-07-10)
    Several new techniques are developed within the previous couple of years that convalesce results on special filters by take away the noise additional with success whereas protective the sides within the information .Image ...
  • ENERGY AND EXERGY ANALYSIS OF ELGUNIED SUGAR FACTORY 
    Abdullah, Mohammednour Mohammed; Supervisor,- A. A. A. Abuelnuor (Sudan University of Science and Technology, 2016-05-10)
    Biomass cogeneration systems can generate power and process heat simultaneously from a single energy resource efficiently. The sugar cane industry represents one of the most important biomass cogeneration systems which ...
  • Implementation of IEC 61850 Based on Substation Au-tomation Systems 
    Saeed, Hind Saeed Ali; Supervisor,- Rashid Abd Alhaleem (Sudan University of Science and Technology, 2016-04-10)
    The standard IEC61850 is the first standard that considers all the communication needs within a substation. The main goal of this standard is to support interoperability of IEDs, to allow IEDs from different manufacturers ...
  • Design of a New Oil Cooling Lubricant Closed System for Gas Turbines in Gari (1, 2) Power Station 
    AHMED, AHMED MAHJOUB MIRGHANI; Supervisor,- Ali Mohammed Hamdan Adam (Sudan University of Science and Technology, 2016-08-10)
    The cooling lubrication oil of the turbine gas in GARI Thermal Station (1and 2) depends on the passage of the lubricating oil outside the tubes of the heat exchanger, and the cooling water from the cooling towers go to the ...
  • NONLINEAR DYNAMIC ANALYSIS OF TALL BUILDINGS UNDER WIND LOADS 
    ALI, HIND MOHAMMED HASSAN; Supervisor,- Abdelrahman Elzubeir Mohamed (Sudan University of Science and Technology, 2016-06-10)
    In this research, the structural systems normally used in tall buildings are presented. The linear and nonlinear finite element analysis of tall buildings under wind loads is carried out. The main purpose was to study ...
  • Concept and Techniques of Value Engineering in Construction Industry in Sudan 
    Hamaza, Ibrahim Habiballa Ibrahim; Supervisor,- Awad Saad Hassan (Sudan University of Science and Technology, 2016-05-10)
    The value Engineering is a modern sciences which is suitable for the developing countries especially like , Sudan, which witnesses critical crucial economic situations, value engineering is concerned with providing and ...
  • Power Flow Control and Inter-Area Oscillation Mode in Sudan and Ethiopia Tie Line 
    Mohamed, Mahmoud Elsir; Supervisor,- Yousif Hassan Abdalrahim; Co Supervisor - Abdel Aziz Yousif Mohamed (Sudan University of Science and Technology, 2016-07-10)
    Steady state instabilities cause problems in electrical power system all over the world. Most of the time potential instabilities are undetected by planning and operational engineering studies, until some particular condition ...
  • Comparison between Newton –Rephson Method and Particle Swarm Optimization in the Analysis of Economic Load Dispatch 
    Hassan, Rihab Hassan Abdelghafour; Supervisor,- Mohammed Osman Hassan (Sudan University of Science and Technology, 2016-05-10)
    The objective of the thesis is to introduce the importance of Economic load Dispatch in a power system. The Economic Dispatch means, to find the generation of the different units in the power system so that the total ...
  • Human Generated Power by Using Piezoelectric Transducer 
    Farag, Tasabeeh Khalid Mohamed; Supervisor,- El Khawad Ali El Faki (Sudan University of Science and Technology, 2016-09-10)
    The importance of using a human energies to charge electronic devices have increased in recent decades at a faster rate than it was with previous decades, studies have shown that human power is the ability(energy)to be ...
  • Performance Analysis of Hybrid Wind- Solar Generation system 
    Abd Elrahim, Salma Yousuf Hassan; Supervisor,- Nagm Aldeen Abdo Mustafa hassanain (Sudan University of Science and Technology, 2016-06-10)
    Technically a system which is entirely dependent only on renewable energy sources cannot be a reliable electricity supply, especially for isolated loads in remote areas. This because the availability of the renewable ...
  • Water Pump Control Based on Microcontroller and Water Level Sensors 
    BAKHEET, HOZUIFA ABD ELKARIEM YAGOB; Supervisor,- ZAKARIA ANWAR ZAKARIA (Sudan University of Science and Technology, 2016-06-10)
    Pump control system is designed to monitor the level of water in the overhead and underground tank through water level sensors, and run the pump only when the water level in the underground tank is up to the position of ...
  • Concrete Formwork Analysis and Design 
    Alhaj, Nahla Awad Elkareem Ahmed; Supervisor,- Fath Elrahman Mohamed Adam (Sudan University of Science and Technology, 2016-07-10)
    This thesis presents a method for the design of high elevated flat slab formwork. The method defines the primary stages of the design process, determines the detailed procedure within each stage, and identifies the basic ...
  • SUGGESTING A SUITABLE MATERIAL FOR THE SOCKET of A PROSTHETIC KNEE 
    Abdalla, Mohamed Ali Mohamed; Supervisor,- Yessin Mohamed Hamdan Adam (Sudan University of Science and Technology, 2016-08-10)
    This research tried to suggest a suitable alternative material instead of that used in manufacturingsocket by the national authority for prosthetics and orthotics. Beside that this research focused on finding suitable ...
  • Study of the Impact of Erosion and Deposition in Nile Agricultural Lands Using GIS and RS 
    Taha, Bassam Awad Khalaflla; Supervisor,- Abdel Rahim Elhag Abdel Aziz (Sudan University of Science and Technology, 2016-09-10)
    This research studying the impact of erosion and sedimentation processes on the Nile River, positioning influence and the erosion of its banks and its impact on Nile agricultural land in the area at Moqren Elnilein and ...
  • Applying Lean Construction Concepts to Construction Industry in Sudan 
    Awad, Ibrahim Mohammed Omer; Supervisor,- Salah Abdalaziz Ajban (Sudan University of Science and Technology, 2016-09-10)
    The construction industry in Sudan plays a major role in the economy via its significant share in the Sudanese Growth Domestic Product (GDP). The Sudan's construction industry faces numerous problems and obstacles which ...
  • Exergy Analysis of Combined Cycle Power Plant (GARRI”2” 180 MW) 
    Mohieldein, Siddig Abuelgasim Abbas; Supervisor,- A. A. A.Abuelnour (Sudan University of Science and Technology, 2016-01-10)
    In recent years the entire world is a warring about energy resources limitation, specifically Sudan country confronts critical crises in fossil fuel resources and yet more of electricity energy producing from fired thermal ...
  • Design and modeling study of roll forming machine for a U-Shape channel products 
    Elshiekh, Hammam Abbas; Supervisor,- Abdalfatah Belal (Sudan University of Science and Technology, 2016-08-10)
    Manufacturing technology of roll forming is one of the important methods and technologies of metal shaping. The need for mass production, devoting and optimization of old and conventional methods is playing important role ...
  • Structural Behavior of Power Transmission Towers 
    Mohammed, Omran Elbashir; Supervisor,- Abusamra Awad Attaelmanan (Sudan University of Science and Technology, 2016-03-10)
    This research is concerned with analysis and design of the power transmission towers. Three types of the power transmission towers were considered in this research to investigate their structural behavior. Data have been ...
  • shear capacity of R.C Deep beams strengthened by Carbon Fiber Polymer (CFP) by using Different Methods 
    Ahmed, Abdallah Gassem Elsseed Mohamed; Superviser,- Abusamra Awad Attaelmanan (Sudan University of Science and Technology, 2016-08-10)
    In this study the carbon Fiber Reinforcement Polymer (CFRP) on increasing shear capacity of reinforcement concrete deep beams. Different methods of strengthening of structures were used to calculate shear capacity. These ...

Share

Search SUST


Browse

My Account