Masters Dissertations : Engineering: Recent submissions

  • The Use of Gum Arabic In Concrete Mixes 
    Omer, Nasir Sidig Abdeljaleel; Supervisor ,- Ali Eltom Hassaballa (Sudan University of Science and Technology, 2011-07-01)
    In this research, Gum Arabic, extracted from (Hashab) trees (in western Sudan ) the purest kind of gum, is used in concrete mixes after crushing to be in a form of powder which was dissolved in water to get the liquid ...
  • Application of Network Management System in Mobile Networks and S.M.S Notification System 
    Shamoug, Esamaldeen Ahmed Mohamed Mohamed; Supervisor ,- Abd Alrasol Jabar Alzubaidy (Sudan University of Science and Technology, 2011-10-01)
    The remarkable development of the field of telecommunications in general and mobile communications in particular, has increased the size of these networks and its devices. This large variety in the size of Mobile networks ...
  • Computer Based Identity Card Design 
    Haithami, Salem Salah Salem; Supervisor ,- Abd Alrasol Jabar Alzubaidy (Sudan University of Science and Technology, 2011-04-01)
    The identity card is very important for governments, organizations and people. So, it is necessary to create and improve the identity cards that are highly secured and easy to use. The electronic card or (smart card) gives ...
  • Computerize Control for High Definition Camera 
    El-Sheikh, Hamed Fadlalla Abdalla; Supervisor ,- Abd Alrasool Abd Aljabbar Alzobaidi (Sudan University of Science and Technology, 2011-04-01)
    Abstract In recent years television channels witnessed a rapid development to become the fourth power. The transmitted image quality became the greatest concern to these channels, which prompted the presence of cameras ...
  • Implementing Quality of Services in Network Using VOIP 
    Elmahi, Selma Mustafa Mohammed; Supervisor ,- Abd Alrasoul Gabbar Alzubaidi (Sudan University of Science and Technology, 2011-10-01)
    This thesis is focused on the possibility of adding new service Voice over IP (VOIP) computer networks, used by the public institutions as basic services, without substantial addition. VOIP service was added ...
  • Wireless Automated Design for Petrol Pumping Process 
    Gaafar, Osman Ahmed Mohammed; Supervisor ,- Abd Elrasoul Gabar Alzubaidi (Sudan University of Science and Technology, 2011-04-01)
    The main purpose of this research is the studying of design services for the process of pumping petroleum, includes sensors and which operates to measure both pressure and temperature and flow rate in the pipelines, ...
  • Modeling Design for Automated Poultry Stratification Weighing System 
    Babiker, Mohamed Elkhatim AbdAlla; Supervisor ,- Abdelrasoul .G. Alzebaidi (Sudan University of Science and Technology, 2011-01-01)
    The purpose of this research is to show the importance of automation the manufacturing operation. This research is about automated poultry stratification weighing system by using conveyer belt driven by DC motor ,DC arm ...
  • Modeling of Multiple Input Multiple Output Orthogonal Frequency Division Multiplexing (MIMO OFDM) System 
    Abd Elgadir, Ahmed Mohammed Fadul; Supervisor ,- Salah Elfaki Elrofai (Sudan University of Science and Technology, 2011-10-01)
    MIMO-OFDM is a key technology for next-generation cellular communications (3GPP-LTE, Mobile WiMAX, IMT-Advanced) as well as wireless LAN (IEEE 802.11a, IEEE 802.11n), wireless PAN (MB-OFDM), and broadcasting (DAB, DVB, and ...
  • Optimization of Maintenance Management Using Cwork Software Neem Field Greater Nile Petroleum Operating Company 
    Musa, Mohammed Eltayib Elfaki; Supervisor ,- Elkhawad Ali Alfaki (Sudan University of Science and Technology, 2011-06-01)
    Competition among global industrial companies has become feature of this era; this has begun to emerge in the middle of the last century and during vigorous and serious attempts to develop specific industrial criteria ...
  • Cracking & Deflection Of R.C Beam Models Including Additives 
    Abd ELmoumein, Sara Mohammed; Supervisor ,- Salih Elhadi Mohammed Ahmed (Sudan University of Science and Technology, 2011-03-01)
    The aim of this research is to study the effect of liquid additives on strength and behavior of R.C beam models . Cracking and deflection of these beam models has been studied . The liquid ...
  • Traffic Analysis of Mobile Communications for Sudani Service Provider 
    Abdelhadi, Ayman Abdalla; Supervisor ,- Khalid Hamid Bilal (Sudan University of Science and Technology, 2011-07-01)
    The performance of calls Traffic for any mobile service provide concentrated in the planning and development of the network which helps in the better performance. The aim of the project is to study, analyze and evaluate ...
  • DESIGN AND IMPLEMENTATION OF FIRING CONTROL SYSTEM USING MICROCONTROLLER 
    Mohamed, Khalid Said Abdalla; Supervisor ,- Awadalla Taifour Ali (Sudan University of Science and Technology, 2011-12-01)
    The microcontroller has been successfully applied to a wide variety of practical problems such as the firing system. It has been shown that these controllers perform better than conventional controllers, especially when ...
  • SIMULATION AND IMPLEMENTATION OF 2-D TRACKING SYSTEM 
    Ibrahim, Mugeeb El-rahman Adam; Supervisor ,- Saad Daoud Sulaiman Al-Shamma (Sudan University of Science and Technology, 2011-11-01)
    The main objective of this thesis is to simulate and implement two dimensional )2-D) tracking systems using two DC motion control system. In this thesis an introduction has been given to the importance of 2-D tracking ...
  • Simulation Study of a Production System : Applied Study on Atbara Flour Mill Company 
    Eltayeb, Khalid Abd-Allah Ahmed; Supervisor ,- Ahmed Hassan Ahmed (Sudan University of Science and Technology, 2011-02-01)
    Decision making process is one of the significant factors those affect on the success and continuity of any business. Decision making under conditions of uncertainty represents the major problem in most of manufacturing ...
  • Analysis of Hose pump using CFD 
    Khalifa, MahanaYounis Hassan; Supervisor ,- Ali Mohamed Ali Elseory (Sudan University of Science and Technology, 2011-05-01)
    This thesis is an introduction to a new industrial model of positive displacement pump knows by the name ‘Hose Pump’. In this thesis, just a simulation of the shape of hose and watch the changes in speed and other barometers, ...
  • Automation By Using Programmable Logic Controller (PLC) Application on Metal Spinning Machine at YIC 
    Hamid, Ahmed Mohammed Ahmed; Supervisor ,- Elrasoul Gabar (Sudan University of Science and Technology, 2011-01-01)
    This research is to find an approach to how PLC automation control system can implemented, In designing anew PLC control automation replacing an old automation in metal spinning machine, which is composed of contactors ...
  • DESIGN OF AN AUTOMATIC PARKING SYSTEM USING RADIO FREQUENCY IDENTIFICATION (RFID) 
    Suliemen, Eihab Ahmed; Supervisor,- Awadalla Taiyfour Ali (Sudan University of Science and Technology, 2011-02-01)
    Over the last decade radio frequency identification (RFID) technology has grown at a formidable rate, thereby creating new and improved service at lower cost. This is resulted in an increase in number of users and different ...
  • WARE HOUSE AUTOMATION USING COMPUTER 
    Mohammed, Mustafa Mahmoud Eltayeb; Supervisor ,- Abd Elfttah Bilal (Sudan University of Science and Technology, 2011-02-01)
    This project indicates the steps of the design of handling system model used in control of warehouse, This automatic gripper moves in two axis (X, Y) to any programmed points. Beside, the project indicates the using of ...
  • Development and Application of Software Program for Pavements Design Methods 
    Mohammed, Mashair A.Elrahim; Supervisor ,- Galal A.Alla Ali (Sudan University of Science and Technology, 2011-02-01)
    AASHTO design procedures for pavements design (flexible, rigid and overlay) are reviewed, summarized and presented. Where necessary, tabulated data, charts and nomographs involved in the design are reproduced in equation ...
  • RISE OF VOLTAGE IN ATBARA-PORTSUDAN TRANSMISSION LINE : INVESTIGATION AND SOLUTION 
    Salim, Mohammed Musa Salih Idres; Supervisor ,- Khamis Arbeesh Saad Eldin (Sudan University of Science and Technology, 2011-02-01)
    Transmission Lines voltage are usually controlled by controlling reactive power flow. In order to control the reactive power the generating or absorbing reactive power are used. There are many type of compensation method ...

Search SUST


Browse

My Account