College of Engineering: Recent submissions

  • Pressure Vessels Design and Failure Analysis 
    Hussein, Gaafar Awad Alkarim Mansi; Supervisor ,- Sabir Mohammed Salih (Sudan University of Science and Technology, 2011-05-01)
    In this study, (Pressure Vessels Design and Failure Analysis) the calculation of the thickness and stress of the basic components has been done using the procedure that has been followed in ASME code and other related ...
  • Microcontroller Based System Design For (Airflow Meter) Control 
    ABDRAHMAN, ABUBAKER OSMAN ABDALLA (Sudan University of Science and Technology, 2011-08-01)
    This research describes air flow measurement device based on microcontroller .The design of the air flow meter includes sensors which allow the microcontroller to measure three parameters – air velocity , pressure and ...
  • ingu Using LEDs in Spectrophotometer Design 
    Elhassan, Mnahil Zaki Eissa (Sudan University of Science and Technology, 2011-08-01)
    A spectrophotometer is an instrument that measures the quantitative amounts of light of different wavelengths which are absorbed and transmitted bA spectrophotometer is an instrument that measures the quantitative amounts ...
  • The effects of aeroelasticity phenomenon on the lifting surfaces of subsonic high speed aircraft analytical study 
    Ahmed, Ahmed Abuzaid; Supervisor ,- El Fatih Mekki Marouf (Sudan University of Science and Technology, 2011-02-01)
    The deformation of the flexible structure under aerodynamic loads at subsonic high speeds due to the aeroelasticity phenomenon was not considered in aircraft design until recently. Further studies showed that the deformation ...
  • Programmable Logic Controller (PLC) Based Turbine Protection 
    Ahmed, Ahmed Elsayed; Supervisor ,- Abdallah Salih (Sudan University of Science and Technology, 2011-01-01)
    The turbine protection system protects the turbine from over speeding, monitors all critical turbine parameters, and trips the turbine if a condition exists that could cause equipment damage. The aim of this research is ...
  • A Study of Development of Protective Relays in Khartoum City Transmission and Distribution (110/33/11KV) /33/11 Substations (110/33/11KV) of National Sudanese Electricity Grid 
    Ali, Mosab Mohammed Ahmed Ahmed; Supervisor ,- Khamis Arbeesh Saad Eldin (Sudan University of Science and Technology, 2011-07-01)
    Present power system is a complex network comprising of various power plants interconnected through transmission lines in a grid meeting the growing need of power. With the complexity in network and power distribution, ...
  • Performance analysis of digital modulation on four generation 
    Madani, Tayssier Abbas; Supervisor ,- Amin Babiker Abd Alnabi (Sudan University of Science and Technology, 2011-01-01)
    The objective of this project is to study, analyze and evaluate the performance of digital modulation to the fourth-generation networks through the ability of error rate against signal to noise of BPSK and M-QAM. The ...
  • REMOVING OCULAR ARTIFACTS FROM EEG RECORDING USING AN ADAPTIVE FILTERIING AND WAVELET TRANSFORM 
    EBU ELHASSAN, ELKHATIM MOHAMED AHMED (Sudan University of Science and Technology, 2011-03-01)
    Eye blinks and movements of the eyeballs produce electrical signals that are collectively known as Ocular Artifacts (OA) and these are 10-100 times stronger than EEG signal which is being recorded. Removing artifacts from ...
  • Implementation of Project Managment Technques to Baleela New Airport Project 
    Khider, Ayman Babiker; Supervisor ,- Omer Abd Alnabi (Sudan University of Science and Technology, 2011-08-01)
    This study discussed the level and methods of management followed in Baleela New Air Port project , also this study was carried out to know the methods of planning , monitoring , general ideas about project activities ...
  • INTERFACE BETWEEN CATHODIC PROTECTION AND SCADA SYSTEM : A case Study of PETRODAR Operating Company 
    Wahaballah, Mohammed Islam Gamar eldien; Supervisor,- Awadalla Tayfor Ali (Sudan University of Science and Technology, 2011-01-01)
    This study is an endeavor to highlight spot points on remote monitoring system technology, especially with regard to the Cathodic protection (CP) system, which is normally utilized to treat the metallic corrosion. Though ...
  • Change of Classic Control into Programmable Logic Control Using Logo Language 
    Badr Eldien, Aziz; Supervisor ,- Eisa Bashier Mohammed (Sudan University of Science and Technology, 2011-03-01)
    This project study’s the logo language as used in the international factory for iron and steel (IFS) to change the factory from classically controlled into programmable logic controlled. The logo language depends on ...
  • Liquid-Liquid and Vapor-Liquid Equilibrium for the Design of Extraction and Distillation Columns 
    Nory, Magdah Abdelbasit; Supervisor, Ibrahim Hassan Mohamed Elamin (Sudan University of Science and Technology, 2011-03-01)
    Liquid-Liquid extraction is a separating unit operation process which is well known and well investigated, however, the equilibrium data For mutual solubility and tie lines are difficult to correlate and be applied. ...
  • The Management of health and safety in the construction of the towers : Case Study Alfateh Tower Khartoum 
    Ibrahim, Lamia Mohamed; Supervisor ,- Isam Abbakar Ishaq (Sudan University of Science and Technology, 2011-08-01)
    The study discus to the importance of managing health and safety in the construction and towers of the importance of safety regulations and to increase number of accidents and injuries at construction sites with the ...
  • MECHANICAL SEAL MONITORING AND CONTROL SYSTEM FOR CENTRIFUGAL PUMPS 
    Mohammed, Mohammed Abbadi Ali; Supervisor ,- Fattah Bilal (Sudan University of Science and Technology, 2011-07-01)
    Centrifugal and rotary positive displacements pumps require controlling of the pumped fluids tend to exit through the stuffing box. A mechanical seal is a sealing device which forms a running seal between rotating and ...
  • Application of Micro PAVER Program for PMMS of Central Sudan Roads 
    Mohamed, Mohammed Eisa Abdalla; Supervisor ,- Galal Abdalla Ali (Sudan University of Science and Technology, 2011-05-01)
    The study has developed a pavement maintenance management system (PMMS) for roads which have been constructed by the National Highway Authority (NHA) in Sudan. The scope of the MicroPAVER system aims to manage the maintenance ...
  • A COMPARISON BETWEEN SURFACE FITTING AND ORDINARY LEAST SQUARES PREDICTION TECHNIQUES 
    Abd Alrahman, Ahmed Ibrahim Mohamed; Supervisor ,- Ali Hassan Fagir (Sudan University of Science and Technology, 2011-05-01)
    The basic activities of surveying and geodesy are acquiring data from field observations. However, field activities are usually time consuming and therefore expensive. Mathematical models are usually cheaply adapted ...
  • Design of wirelessly control centrifuge 
    Abdelgadir, Managib Nour Eldin; Supervisor ,- Jacquline John George (Sudan University of Science and Technology, 2011-06-01)
    The centrifuge is considered as an important device in modern life as it is used widely in various aspect of life such as in the medical and industrial field. The main idea of the device is based on the separation of the ...
  • Simulation of Direction Finding for Transmission Sources 
    Elfiel, Tayseer Ali Mohammed Ali; Supervisor ,- Abdelrasool Gabar Alzibaidy (Sudan University of Science and Technology, 2011-02-01)
    Direction finding (DF) refers to the establishment of the direction from which a received signal was transmitted. The source of a transmission located in space via many techniques, one of them is the triangulation method. ...
  • ELECTRICITY SUBTRANSMISSION A STUDY OF KHARTOUM NORTH SYSTEM (33 KV) - (INVESTIGATION & SOLUTION) 
    ABDALLA, MUSTAFA ABDALLA HASABELRASOUL; Supervisor ,- KHAMIS ARBEESH SAAD ELDIN (Sudan University of Science and Technology, 2012-04-01)
    The performance of distribution systems determines greater than 90% of the reliability of service to customers (the high-voltage transmission and generation system determines the rest). In recent years the problem of ...
  • CONTROL OF DC MOTOR BY USING MICROCONTROLLER 
    Taha, Mai Abdallah Mohammed; Supervisor,- Awadalla Taifor Ali (Sudan University of Science and Technology, 2012-05-01)
    The Electric Motor System (EMS) is used widely in different industrial, agricultural and mining applications. However, the speed of the DC electric system is a very vital factor in accomplishing the tasks effectively. This ...

Search SUST


Browse

My Account